Hi everyone,
I have an older kegerator, i just cleaned everything inside amd out. I poured a few beers last night and then a piece that connects the faucet and tower came out. It is not threaded and you just push it in when assembling the keg. This caused beer to spill everywhere. I then fixed the issue and retightened everything I could. At least I think. I then reattached the keg and I now have a slow leak coming from the tower dripping down. The problem is the way this tower works to unhook the faucet and tower the reassembly time is tremendously long and tedious due to the fact that you have to screw a nut onto the facet without being able to use your hands since it is in the tower. I wanted to know if there was either another option for a new tower that would work well. Or if there is an easier fix than disassembling the entire thing
I have an older kegerator, i just cleaned everything inside amd out. I poured a few beers last night and then a piece that connects the faucet and tower came out. It is not threaded and you just push it in when assembling the keg. This caused beer to spill everywhere. I then fixed the issue and retightened everything I could. At least I think. I then reattached the keg and I now have a slow leak coming from the tower dripping down. The problem is the way this tower works to unhook the faucet and tower the reassembly time is tremendously long and tedious due to the fact that you have to screw a nut onto the facet without being able to use your hands since it is in the tower. I wanted to know if there was either another option for a new tower that would work well. Or if there is an easier fix than disassembling the entire thing