Guys,
I have pretty much narrowed down my build using this wiring diagram from PJ:
I was going through Auber's website and found a control panel and they showed the inside of the panel on a similar setup (one element connector with a single PID presumably for eBIAB but I want two element connectors). They are using DIN rail components with breakers. Any preference to go the route that Auber uses (DIN rail components vs contactors and fuses)?
The din rail stuff looks a bit more complicated for my not electrical smart brain.
Thanks
Scott
I have pretty much narrowed down my build using this wiring diagram from PJ:
I was going through Auber's website and found a control panel and they showed the inside of the panel on a similar setup (one element connector with a single PID presumably for eBIAB but I want two element connectors). They are using DIN rail components with breakers. Any preference to go the route that Auber uses (DIN rail components vs contactors and fuses)?
The din rail stuff looks a bit more complicated for my not electrical smart brain.
Thanks
Scott