Hi All,
I've been looking into upgrading my two keggles with 1/2" silver soldered bulkheads like the one's from BrewHardware.com. The problem I noticed was that when I measured the currently drilled hole sizes they were closer to 15/16" or 1" than the recommended 7/8". I am assuming this will be an issue with the fittings from BH. Are there other 1/2" bulkheads that have an outer diameter that would work? Maybe a coupling like this has a 1.06" OD? Or am I just out of luck on this one?
Thanks!
I've been looking into upgrading my two keggles with 1/2" silver soldered bulkheads like the one's from BrewHardware.com. The problem I noticed was that when I measured the currently drilled hole sizes they were closer to 15/16" or 1" than the recommended 7/8". I am assuming this will be an issue with the fittings from BH. Are there other 1/2" bulkheads that have an outer diameter that would work? Maybe a coupling like this has a 1.06" OD? Or am I just out of luck on this one?
Thanks!