TheMerkle
Well-Known Member
I know some of you guys are loathe to approach these threads, and I don't blame you. However, if others are feeling spunky... maybe you can help me fix my first diy controller.
I used the below diagram to assemble my first controller using Aubers EZBoil.
The only change I made was in omitting the lower amperage switch to the controller, and using only the 30a to the heater outlet.
My first test resulted in immediately obliterating both in line fuses. I mean, they didn't just pop, they turned to dust inside.
Any suggestions?
View attachment 1471797214488.jpg
I used the below diagram to assemble my first controller using Aubers EZBoil.
The only change I made was in omitting the lower amperage switch to the controller, and using only the 30a to the heater outlet.
My first test resulted in immediately obliterating both in line fuses. I mean, they didn't just pop, they turned to dust inside.
Any suggestions?
View attachment 1471797214488.jpg