crouchingwombat
Active Member
- Joined
- Feb 15, 2009
- Messages
- 41
- Reaction score
- 1
I have a motorized ball valve and a pid I'm trying to get to work together.
Inkbid itc 106
Door bell transformer
3 wire motorized ball valve
Rt-100 probe
Using to take glycol from a loop to a fermentor until it gets to temp and then close the ball valve when it is at temp. I need to power the ball valve to open the line at the high temp and then close it again once it reaches the low temp.
I can't figure this out, I've been trying but the ball valve wiring and PID programing to sent power to the ball valve twice is stumping me.
Thanks for the help.
Inkbid itc 106
Door bell transformer
3 wire motorized ball valve
Rt-100 probe
Using to take glycol from a loop to a fermentor until it gets to temp and then close the ball valve when it is at temp. I need to power the ball valve to open the line at the high temp and then close it again once it reaches the low temp.
I can't figure this out, I've been trying but the ball valve wiring and PID programing to sent power to the ball valve twice is stumping me.
Thanks for the help.