New Kettle Break in

[dest149]

Do I need to "break in" my new 5 gallon kettle. I just finished washing it, but I was wondering if I needed to boil water in it first, and if so how much for how long. And would I need to clean it again afterwords?

 

[Kaz]

If its stainless steel...just use it. Aluminum benefits from a water boil, it helps build up a protective oxidative layer.

 

[dest149]

it is stainless steel. thanks!

 

[unionrdr]

I love my polished SS brew kettles! Way easier to live with. And I can re-polish them with an SOS soap pad now & then to keep them clean & shiny. After the sos pad,rinse well with hot water,fill part way with hot water again,& wipe it down with a soft cloth to make sure all the pad's soap is gone. Then I dry it off & put it back in the bottom of my fermenter stand/storage unit.

 

[subliminalurge]

Yep, the aluminum does benefit from a "break-in" boil with plain water. No necessary in stainless.

Aside from that, just keep it clean. If you'd be comfortable making a pot of chili in it for your family, then it's clean enough for beer, too.

 

[drainbamage]

SS brew-pots are great! I just give mine a good wipe-down with a wet cloth before brewing (in case it had been sitting for a while and gotten dust on it) and a wash with a little soap and hot water afterwards.

 

[Hillsboro]

Sorry to resurrect this old thread but I just got a new 10 gal mega pot 1.2 and I'm going to brew tomorrow. It sounds like there is no break in for a ss pot but I assume I need to do a quick soap wash, correct? Maybe some oxyclean?

 

[LovesIPA]

I would just use soap and water and run with it.