eryk4381
Well-Known Member
OK guys I am stuck. I have a total build almost setup and will be posting a full write up once I am finished but I need assistance. I have:
1 Inkbird Timer
2 Inbird ITC-106 Temp controllers
2 Honeywell VR8200 gas valves
I am trying to connect this altogether to time both the MLT and HLT. I have it all wired up for power and I get were the 120 goes into the controllers and the temp probes but the part where it goes it all goes OUT to the SSR's and the 24v Transformer I have to the gas valves. I fluent in electronics but not gas and I just cant for the life of me figure this out.
How do the controller's power the transformer to then power the gas valves?
Where do the SSR's come in since I'm reading 12V coming out of the temp controllers OUT NO side at only 12V?
1 Inkbird Timer
2 Inbird ITC-106 Temp controllers
2 Honeywell VR8200 gas valves
I am trying to connect this altogether to time both the MLT and HLT. I have it all wired up for power and I get were the 120 goes into the controllers and the temp probes but the part where it goes it all goes OUT to the SSR's and the 24v Transformer I have to the gas valves. I fluent in electronics but not gas and I just cant for the life of me figure this out.
How do the controller's power the transformer to then power the gas valves?
Where do the SSR's come in since I'm reading 12V coming out of the temp controllers OUT NO side at only 12V?