pentiumone133
Well-Known Member
- Joined
- Nov 13, 2012
- Messages
- 62
- Reaction score
- 7
Ive got a cheap mypin ta4 pid controller for my RIMS setup that has been working well with a thermocouple. Recently I acquired a new RTD sensor to replace the TC so I can disconnect the sensor from the control box instead of leaving it connected all the time. I cant figure out how to wire it up, and I have no idea what settings to change on the PID to change it to accept RTD input. Can anyone help?
Heres a photo of the schematic on the PID:
http://imgur.com/vDrFbqi
The RTD sensor has two white wires and one red wire. Heres a photo:
http://imgur.com/onRa64h
Thanks!
Heres a photo of the schematic on the PID:
http://imgur.com/vDrFbqi
The RTD sensor has two white wires and one red wire. Heres a photo:
http://imgur.com/onRa64h
Thanks!