GeoffreyKerns
Member
So I made a 1.5L starter on 12/6 for my first batch (OG of 1.038). Covered with a piece of sanitized foil and let the magic happen. I saw a good amount of very fine bubbles after just about 6 hours that subsided after about 30 hours. I tossed the starter into the fridge at this point and left it overnight.
This afternoon, I decanted a bit of the liquid off and took a hydrometer reading... 1.018... Wonderful.
So here is where the problem comes in... I took a whif and got a pretty strong acetic acid smell. Taste was pretty much the same as the smell.
Bacterial contamination, right? I just wanted to make sure that Im not overreacting by wanting to send this starter down the drain and just buy 2 vials of yeast for brew day on Saturday.
At least I apparently screwed up the sanitation on a starter and not my whole first batch. Come Saturday, Im treating this place like an operating room.
This afternoon, I decanted a bit of the liquid off and took a hydrometer reading... 1.018... Wonderful.
So here is where the problem comes in... I took a whif and got a pretty strong acetic acid smell. Taste was pretty much the same as the smell.
Bacterial contamination, right? I just wanted to make sure that Im not overreacting by wanting to send this starter down the drain and just buy 2 vials of yeast for brew day on Saturday.
At least I apparently screwed up the sanitation on a starter and not my whole first batch. Come Saturday, Im treating this place like an operating room.