StunnedMonkey
Well-Known Member
I kegged a batch a few days ago at 10 psi. It's not intended for drinking for a couple of weeks. This morning I noticed that it's leaking around the lid...I see bubbles there. I gave it a 30 psi shot and it seemed to seal back up, but now that I've backed it down to 10, I dunno if it'll hold.
If I have to move this batch, what's the best way to do it? I'm considering making a beer line with liquid ball locks on both sides, connecting them to the out posts of the leaky keg and an empty good keg, then pushing it from one to the other under low pressure (5 psi?). Is there a better way? Any way to try and get a good seal on the keg in place as opposed to moving the beer?
If I have to move this batch, what's the best way to do it? I'm considering making a beer line with liquid ball locks on both sides, connecting them to the out posts of the leaky keg and an empty good keg, then pushing it from one to the other under low pressure (5 psi?). Is there a better way? Any way to try and get a good seal on the keg in place as opposed to moving the beer?