Stout Man
Well-Known Member
I have mounts for the valve and sight tube on my HLT and Kettle. My MT has one valve mount. I was going to originally go ahead and use a SS t-tube so I could have a Thermometer going through all of it and then have the valve go off at the joint. I am now second guessing this and wondering if I should have an additional coupling welded so that the thermometer has its own specific spot, rather than being at the end of some SS joints.
Here is a link to what I originally wanted to do: http://brewing.velociworks.com/mashtun1.jpg
I've just had second thoughts about getting good temperature readings on the mash and kettle. I'm not doing any RIMS or HERMS system, I just want to be accurate and not have to be be heavily modifying my system, no more welding basically.
Here is a link to what I originally wanted to do: http://brewing.velociworks.com/mashtun1.jpg
I've just had second thoughts about getting good temperature readings on the mash and kettle. I'm not doing any RIMS or HERMS system, I just want to be accurate and not have to be be heavily modifying my system, no more welding basically.