@Thorrak : Apologies for not being clear in my original post. By "config", I was referring to the iSpindel setup, where you pull the PCB out and initiate the configuration mode by hitting the ESP8266 reset button a couple of times, assuming you had the PCB in the petling.
None of what I'm working through is at all an issue with Fermentrack. Fermentrack was only mentioned because it'd worked well for iSpindel calibration before, and was handy when I was trying to figure this out.
None of what I'm working through is at all an issue with Fermentrack. Fermentrack was only mentioned because it'd worked well for iSpindel calibration before, and was handy when I was trying to figure this out.