I have a Bayou Classic 44 QT SS kettle. After my first AG batch, I quickly learned that a full boil kettle is heavy and pouring hot water tricky. I bought the weldless ball valve and bulkhead from Bargainfittings.
My question is simple, how do I figure out where to install the valve? I know on the kettle, but how high up should I go? I am used to using powertools, but still am nervous about drilling a hole in my shiny kettle. So I want to make sure I do this right the first time. I have a step bit.
Thanks
My question is simple, how do I figure out where to install the valve? I know on the kettle, but how high up should I go? I am used to using powertools, but still am nervous about drilling a hole in my shiny kettle. So I want to make sure I do this right the first time. I have a step bit.
Thanks