hokenfloken
Well-Known Member
I bought a 50qt Rubbermaid cooler to use as a mash tun.
http://www.rubbermaid.com/Category/Pages/ProductDetail.aspx?Prod_ID=RP091808#
The spigot is on the long edge of the cooler rather than the short edge. I've read about only slotting the longitudinal pipes in a manifold to prevent channeling. Will this work with the manifold feeding to a spout on the long edge of the cooler? Would I still only slot the pipes that run the length of the cooler? I can post pictures of the cooler and the desired manifold design when I get home.
http://www.rubbermaid.com/Category/Pages/ProductDetail.aspx?Prod_ID=RP091808#
The spigot is on the long edge of the cooler rather than the short edge. I've read about only slotting the longitudinal pipes in a manifold to prevent channeling. Will this work with the manifold feeding to a spout on the long edge of the cooler? Would I still only slot the pipes that run the length of the cooler? I can post pictures of the cooler and the desired manifold design when I get home.