autobaun70
Well-Known Member
I am working on setting up an automated MLT, using a basic brutus 10 design, and have a few questions about the electronics.
I will only be controlling 1 burner for now, but may automate the HLT later on. I am looking at the Auber SYL-1512A controller. It lists the input voltage at 85V A/C - 260V A/C, and the output voltage at 240V AC. Is the output voltage a constant 240V, or does it replicate the input voltage? Also, can I just run that directly into a transformer, and control a honeywell gas valve (24V A/C), or do I need to tie the controller to a relay, and keep the 24V a/c transformer switched from there?
I will only be controlling 1 burner for now, but may automate the HLT later on. I am looking at the Auber SYL-1512A controller. It lists the input voltage at 85V A/C - 260V A/C, and the output voltage at 240V AC. Is the output voltage a constant 240V, or does it replicate the input voltage? Also, can I just run that directly into a transformer, and control a honeywell gas valve (24V A/C), or do I need to tie the controller to a relay, and keep the 24V a/c transformer switched from there?