I recently came in to a number of kegs in my attempts to build my homebrew single tier all-electric rig. I only needed three, but figured the additional kegs could be used for brewing by fellow homebrewers. I have 6 kegs remaining from various brands. On the keg you see here I have welded a single 1/2" FPT half-coupler in the top position for use with a dial temperature gauge. There is a full coupler in the bottom position that is used for draining. Since it is a full coupler you can mount both a valve on the outside and a dip tube or similar device on the inside. All the welds have been dimpled and sanitary welded using a TIG welder with argon purging (outside/inside). Of the 6 kegs this is the only one with couplers welded on it. If you have a particular location you would like the couplers welded I can put them there after payment. The top has been cut using a plasma cutter and compass jig to ensure roundness. The lid edges have been smoothed with an angle grinder and flapper wheel. Additional couplers/fittings can be welded for $20 per fitting. Please contact via pm if you are interested or have any questions.