Guys,
I finally retrieved some beer kegs that had been stolen from garage. The thieves were rough on them when they tried to sell them at the scrapyard. I cut the top off 2 kegs to make keggles. Since my knowledge of metallurgy is limited, I want to know if can fix the dents on these kegs. Is it alright to hammer out the dents form the inside of the keg. Also, It is OK to use a grinder on the outside of the keg. Any input would greatly appreciated!
DocDave
I finally retrieved some beer kegs that had been stolen from garage. The thieves were rough on them when they tried to sell them at the scrapyard. I cut the top off 2 kegs to make keggles. Since my knowledge of metallurgy is limited, I want to know if can fix the dents on these kegs. Is it alright to hammer out the dents form the inside of the keg. Also, It is OK to use a grinder on the outside of the keg. Any input would greatly appreciated!
DocDave