Condo Brewing V2 - Custom eBIAB Build Thread (120V)

[PsychoBiter]

The whirlpool isn’t very effective.

Have you tried cocking the pickup tube for the pump to 90 degrees to catch the flow of the whirlpool? Our diptube was so close to the bottom, it wouldn't allow the pump to pick up the volume we needed for good flow. I start out with it cocked 90degree for the whole process until it is time to transfer to fermenter so it will pick up as much wort as possible. You cold also try crimping down the output on the whirlpool fitting to create more of a jet. We did that as well and helped, but our is a cheap copper whirlpool vs a nice stainless unit.

 

[PsychoBiter]

Also if you do end up looking for a new pump, I recommend the Steelhead 2.0. It is 24V as well and very quiet. You will need to add a ball valve to limit your output, they can move some wort.

 

[Dirkdiggler027]

Excellent build thread, thanks Metzen. I sent a pm regarding the spring loaded kettle holders as I've been searching for a solution and yours looks perfect...

 

[auburntsts]

Any updates, especially with regards to switching to the 2250W element and the boil condenser? I'm curious as to what the mash temp to boil time is with the higher power element. Also do you do full volume, no sparge mashes?

What are your thoughts about using a BIAB false bottom like this:

vs. the DYI supports for the basket?

 

[Skjold]

I’ve researched a few of the turnkey systems, including the High Gravity, Clawhammer, Unibrau, GF, etc. All look good, but each has one or two things that I would change. So I’m building this custom and completely to my specs (within my means).

I've been trying to debate going eBIAB vs some sort of 2 vessel config, and I just wanted to say your build is seriously inspiring for DIY BIAB. I've looked at those pre-built systems as well, but had various complaints/tweaks for each one.

If you're still following this thread, I'm wondering if you have any updates that would help someone considering a similar route? With the new pump and that custom basket, have you experienced any stuck recirc?

One of the things I'm skeptical of with BIAB in general is recirc/channeling around the grain... so that basket is pretty awesome!

 

[Wagon_6]

DIY Swing-up Basket Supports

So I decided to take a few SS wire clamps and some 3mm steel rods and build a support that I can clamp onto the handle and swing up when necessary.

Parts list:
- 3mm x 12” steel rod (x2)
- 4mm rod collar (x2)
- 1.5” expansion spring (x2)
- 8mm rubber coated SS clamps (x8)
- 3mm ball bearings (x4)
- 1” angle with two holes (one on each side) (x2)
- M6 bolt and nut (x4)

Can you provide more details on how you assembled these? Also, where did you source all the parts from?