AkBrewer49
Member
- Joined
- Feb 4, 2013
- Messages
- 13
- Reaction score
- 1
So I have a control panel similar to Kal's. I was doing a "dry" run yesterday and after about 40 min of heating the strike water to 160 from about 40, the CB tripped. I shut it down, let it sit and fired it up again. It tripped 3 or 4 more times until it got to temp. It then functioned fine through the mash and sparge. I transferred water to the BK and cranked up the other side. The water was about 155 and as I was bringing about 12 gal to boiling, the other CB tripped at about 15min and kept tripping. I could not get it above 188....
It is a 50amp panel. I am thinking heat related, but not sure. I am running 10ga to all elements and parts.....
It is a 50amp panel. I am thinking heat related, but not sure. I am running 10ga to all elements and parts.....