eeverwine
Well-Known Member
Ok I know I'm probably beating a dead horse somehow, but I couldn't find specific info on this.
I set my Johnson Controls A419 temp controller to Cooling/Cut Out mode. Now for that I have the jumper barely on the prongs at all, is that right? Or should it be halfway or something?
I made the setpoint 63F for fermentation, differential 1, and ASD 10 minutes.
When I plug the freezer in to the wall outlet, the compressor cycles on and it starts to cool. When I plug it in to my Johnson Controls temperature controller, the freezer doesn't do anything. It just sits there off.
Is there something I'm doing wrong? I know both of these things work independently of each other, as I had it set for heating/cut out mode with a heater.
I just started a 60 min boil and it would be awesome if someone could give me some info before I transfer to a carboy.
Thanks in advance,
Eric
I set my Johnson Controls A419 temp controller to Cooling/Cut Out mode. Now for that I have the jumper barely on the prongs at all, is that right? Or should it be halfway or something?
I made the setpoint 63F for fermentation, differential 1, and ASD 10 minutes.
When I plug the freezer in to the wall outlet, the compressor cycles on and it starts to cool. When I plug it in to my Johnson Controls temperature controller, the freezer doesn't do anything. It just sits there off.
Is there something I'm doing wrong? I know both of these things work independently of each other, as I had it set for heating/cut out mode with a heater.
I just started a 60 min boil and it would be awesome if someone could give me some info before I transfer to a carboy.
Thanks in advance,
Eric