rtstrider

Leave it open immediately after pitching / mixing the yeast. When you do close it make sure to remove the jar as there is no pressure...

I fill the collection chamber with beer via a picnic/ party tap to brim with beer and foam before reattach after yeast dump. I tend to...

I have no trouble dropping temperature with around 15 PSI on the fermenter. I can do it with as low as 7 PSI without any problems. It...

Thank you so much for that! I did order a ball lock fitting and prv valve for the collection chamber but for other reasons lol It was...

It depends on what pressure you are fermenting at. If you keep the total pressure at 1 bar (15 PSI) or less you should be good. DO NOT...

Hey all! I just ordered the Fermzilla tri conical and will be playing with pressure fermentation right out of the gate. I've seen a...

Try using 1.8 qt per lb water to grist ratio. That has helped out significantly.

I crush around .040" and it works fine with the Northern Brewer Hullwrecker. I've found anything finer than that is clog city...

I just ordered a pack and will be banking it up. I'll let you know the results!

Finished soaking the malt pipe. Everything is air drying now. I can't believe how dirty this got. Will definitely have to CIP after...

Not sure if this is a true deep clean but I do this after every brew: remove pipe and false bottom and rinse off with sprayer. Spray and...

Realized I forgot to soak the malt pipe...DOH! Going to do that after work today. I will say the unit definitely smells a heckuva lot...

How often does everyone deep clean the Brewzilla? I had neglected to do so in 20+ batches (at least 15 batches with the HED). The HED...

This is in line to be a rebrew! Will be brewing this in 2 weeks using WLP029 this time fermented around 60F for the first few days...

All I keep reading is how clean a yeast it is, and every time I brew with it, I can tell it's Kviek. Especially in lighter beers...