After using it for 2 batches, my Magic Siphon "came apart". There's a foot that was glued to the long end of the cane that goes inside the tube. The tube sealing gasket is attached on the foot. The end of the cane evidently had only a smidgen of glue holding it inside the foot. I managed to get the cane into the foot, which seemed like a decent snug fit. However, when I attempted to rack, it entrained air into the cane and up and out the hose with the beer--not good!
What kind of food grade glue can I use to properly attach the foot and provide a good seal to prevent air introduction? Thanks.
What kind of food grade glue can I use to properly attach the foot and provide a good seal to prevent air introduction? Thanks.