BrewPi not assigning sensors

[NoDoubtAddMoreHops]

I just got my Brewpi (Raspberry Pi 2/Arduino Uno R3) running. Seems to be fine, except I'm trying to assign devices. For whatever reason, I cannot assign one of the DS18B20 temp sensors to "beer temp", I set all parameters and hit apply and it just reverts to whatever the Arduino had set after you hit refresh. I was able to set the room temp sensor, fridge temp sensor but not the beer temp.

Any ideas? Anyone else seeing these idiosyncrasies with this set up? Thank god I just got a pack of Hoptimum to distract me for a bit.

EDIT: Apparently temp sensor has to be assigned to "Beer 1" instead of "Chamber Device" to work as beer temp sensor. Derp.

 

[day_trippr]

Try removing all three sensors using the gui, then reboot the RPi and the Uno, and assign them again...

Cheers!