illin8
Well-Known Member
I'll be setting up my PID this week and had a couple quick questions:
1. Is there anything I need to do as far as initial setup when I power it up and do a test run (just heating water)? Any specific settings that need to be manipulated?
2. I have Auber RTD...is it accurate straight out of the box or will I need to do any calibration?
Can't wait to finally try it out...
1. Is there anything I need to do as far as initial setup when I power it up and do a test run (just heating water)? Any specific settings that need to be manipulated?
2. I have Auber RTD...is it accurate straight out of the box or will I need to do any calibration?
Can't wait to finally try it out...