Attaching tower to pin lock adapters? (probably dumb)

[stigs]

Yesterday I got (what I thought) were all the parts needed to finish my kegerator conversion.

The tower I have terminates 3/16" tubing to what I would call a nozzle and nut adapter on the end, like a hose. I am using pin lock kegs and have adapters for them (these: http://www.beveragefactory.com/draftbeer/couplers/homebrew/PLCP-CS.shtml). So how do I connect the tower hoses to these? Snip off the ends and just attach the tubing to the pin lock adapters?

The parts I got did come with one of these: http://i52.tinypic.com/24nfz39.jpg

Is this the adapter to connect the tower tubing? What is this called so I can get another set (2 line system).

Thanks!

 

[Joshaw50]

Yesterday I got (what I thought) were all the parts needed to finish my kegerator conversion.

The tower I have terminates 3/16" tubing to what I would call a nozzle and nut adapter on the end, like a hose. I am using pin lock kegs and have adapters for them (these: http://www.beveragefactory.com/draftbeer/couplers/homebrew/PLCP-CS.shtml). So how do I connect the tower hoses to these? Snip off the ends and just attach the tubing to the pin lock adapters?

The parts I got did come with one of these: http://i52.tinypic.com/24nfz39.jpg

Is this the adapter to connect the tower tubing? What is this called so I can get another set (2 line system).


Thanks!

Evenly cut the hose and push onto the hosetail of the pin lock adapter and tighten using a hose clamp. The other end up the hose that hooks up to the faucet tower only requires the 3 small pieces from your picture to create the 2nd hosetail assembly and clamp that end on as well.

The large item in your Picture is a Duplex Coupling used for cleaning out your beer lines.