Hey all
Building a e brew system and would like to buy some knockout punches if someone has some.
I've been doing it so far with a step bit, but I'd like to speed up the process and obtain better results at the same time.
I'm not positive which sizes I need at this point, but I'll mention what I have left to make holes for
Heating elements (1-1/4" I think?)
Ball valves (1/2" I think?)
Site glass (not sure atm)
I have various holes in my control panel i still need to make, but I should be able to get them with a step bit unless someone has some smaller size punches. To fit:
XLR plugs
aviation plugs
I'll need to check on these sizes.
And I have one huge hole that is much bigger than my step bit. It's for a flanged NEMA 14-30 outlet. Will check on this size too.
Wasn't too sure of the sizes at this point, but I want to start getting the word out in case people see this!
Thanks!!
Building a e brew system and would like to buy some knockout punches if someone has some.
I've been doing it so far with a step bit, but I'd like to speed up the process and obtain better results at the same time.
I'm not positive which sizes I need at this point, but I'll mention what I have left to make holes for
Heating elements (1-1/4" I think?)
Ball valves (1/2" I think?)
Site glass (not sure atm)
I have various holes in my control panel i still need to make, but I should be able to get them with a step bit unless someone has some smaller size punches. To fit:
XLR plugs
aviation plugs
I'll need to check on these sizes.
And I have one huge hole that is much bigger than my step bit. It's for a flanged NEMA 14-30 outlet. Will check on this size too.
Wasn't too sure of the sizes at this point, but I want to start getting the word out in case people see this!
Thanks!!