Hey all ! After what i will reluctantly refer to as my 1st attempt failure to chill my wort using the Ole snow bank and spooning the wort, I've been reading alot of post on chillers as well as looking into whats on the market for sale, I've decided to design and produce the ultimate chiller.
I guarantee it will do a great job, it will be solid and not the typical coil design, which i believe to be flawed. All I'll say is from what I've seen all the chillers address the matter of cooling the wort from the outer edges, my intention is to approach not only the outer edges but the center as well. Now what i need to know is, is there a such thing as cooling the wort to fast ? the answer to this question will determine certain particulars in my design. After its been built and tested I'll gladly post my design prints and pic's.
I guarantee it will do a great job, it will be solid and not the typical coil design, which i believe to be flawed. All I'll say is from what I've seen all the chillers address the matter of cooling the wort from the outer edges, my intention is to approach not only the outer edges but the center as well. Now what i need to know is, is there a such thing as cooling the wort to fast ? the answer to this question will determine certain particulars in my design. After its been built and tested I'll gladly post my design prints and pic's.