jamesmiller982
Member
- Joined
- Sep 22, 2012
- Messages
- 14
- Reaction score
- 0
I am trying to figure out the Brun Water Program and I need a little help. I have most of the water quality report but it looks like i am missing some information and some other info I do not know where to put it.
Here is the info I have
Calcium- 24 mg/L is this the same as ppm?
Mag 14.5
Potassium- unknown- Is this imoprtant?
Bicarbonate- 6 mg
Carbonate Hardness- 74 mg- I did not know where to put this?
Non-caronate hardness- 46 mg- I did not know where to put this.
Chloride- Unknown- Is this important?
Nitrate (N03)- 4mg
Nitrate (NO2) unknown- Is this important?
PH 9.3 is this high?
If i am need the unkowns I may be able to send to a lab if I need to. What other info do i need to have. Once I put into the chart what tab should I look at next? I am going to make Denny Rye IPA. What profile would I go with #48 pale ale? Where do I enter this information? Thanks for the help.
Here is the info I have
Calcium- 24 mg/L is this the same as ppm?
Mag 14.5
Potassium- unknown- Is this imoprtant?
Bicarbonate- 6 mg
Carbonate Hardness- 74 mg- I did not know where to put this?
Non-caronate hardness- 46 mg- I did not know where to put this.
Chloride- Unknown- Is this important?
Nitrate (N03)- 4mg
Nitrate (NO2) unknown- Is this important?
PH 9.3 is this high?
If i am need the unkowns I may be able to send to a lab if I need to. What other info do i need to have. Once I put into the chart what tab should I look at next? I am going to make Denny Rye IPA. What profile would I go with #48 pale ale? Where do I enter this information? Thanks for the help.