IloveWorts
Well-Known Member
This is bad ass
if drilling on the rear, couldn't you do an 'exploratory' drill by using a hole saw to cut just the exterior and then poking the foam to see if there are any coils?
Every once in a while I see this thread pop up and think "this f'n thing!".
Good job, OP. :rockin:
JonW, Great work. Since Imitation is the sincerest form of flattery, I'm stealing most of your ideas for my project. I was on my way to buying a Danby and modifying it to have 2 kegs available, but this project fits the need for a keezer and a place to lager in the same bill.
I found an old Kenmore 20+CF last week on CR for $100. Only issue was one of the door shelf brackets was broken. I spent the weekend cleaning it up and readjusting the thermostat. It is steady 39.5 F now. This evening I'm going to disable the defrost timer, build the wire shelf support and make the door brackets for the drip tray shelf.
Thanks for the inspiration, I'll post pictures once I've completed the build.
I would leave the defrost timer intact.
Keep in mind that most manual defrost uprights have shelves which are evaporator coils - which means they are not relocatable.
Enter your email address to join: