picked up a used BC55 model Uline kegerator, with nice aluminum bottle pretty full of gas plus pony keg shell and sanke tap. the tower looks rough, has a tap rite stamp on faucet. beer line needs replacing, cause i don't know if it has been cleaned ever! the sanke tap has a wingnut style yellow colored handle. no brand name- can I disconnect lines and soak it to clean it up- or should I buy a new one?
regulator has a single gauge with a "Banner" brand marking on the gauge itself. Banner on the shut off valve- i wonder if this regulator controls back flow?
the tower and faucet i think i will replace with a good perlick faucet- either buy a tower or make the DIY one from this forum- along with copper tubes for cooling lines. The beer line has stainless 90 elbows where it attaches to faucet- could reuse those maybe.
already have a 3 tap keezer for the homebrew- this little unit i intend to use primarily for sanke kegs when my brewing time is limited and i am being lazy!
any thoughts on the uline- not finding much info on them. or any of these components and their quality?
regulator has a single gauge with a "Banner" brand marking on the gauge itself. Banner on the shut off valve- i wonder if this regulator controls back flow?
the tower and faucet i think i will replace with a good perlick faucet- either buy a tower or make the DIY one from this forum- along with copper tubes for cooling lines. The beer line has stainless 90 elbows where it attaches to faucet- could reuse those maybe.
already have a 3 tap keezer for the homebrew- this little unit i intend to use primarily for sanke kegs when my brewing time is limited and i am being lazy!
any thoughts on the uline- not finding much info on them. or any of these components and their quality?