jppostKW
Well-Known Member
I am finalizing the build of my brew stand a diy thread is upcoming. One of the problems I ran into is the height in my 2 tier stand would make the hoses prone to kinking i looked around for a while and finally found a solution. I added a spring to each end of my female camlock fitting hoses I found these springs at work they are from a four prong trailer plug made by philips industries. I am talking to the company to see if the cable guard for the 15-430 is available alone they have larger ones for 7 wire cables but i cant find the smaller ones
trailer plugs
they fit perfectly over 1/2" OD 3/4" OD silicon tubing. slide right up to the clamp on the barb fitting and i cant get it to kink if I tried!!!
heres the pics
trailer plugs
they fit perfectly over 1/2" OD 3/4" OD silicon tubing. slide right up to the clamp on the barb fitting and i cant get it to kink if I tried!!!
heres the pics