jjkeegan86
Super Bit Brewing
- Joined
- Jul 31, 2014
- Messages
- 88
- Reaction score
- 21
Making the move to electric. I have a 3 vessel keggle setup, but I need to shrink my brewing footprint. I toyed with keeping one keggle and adding a rims tube for mashing and then gas firing one keggle. But decided to go to a full ebiab setup. I've got a spike kettle on order and want to get started on a control panel.
I'll be using craftbeerpi instead of pids. I already have the raspberry pi.
I've attached a wiring diagram and the control box part list. I'm not sure about the enclosure. Didn't know if there was a reason not to go with plastic. Also not sure how to wire an on-off-auto switch for the pump. The way I have it does not seem right. Is there any reason to avoid using an ssr for a chugger pump? I could use a regular relay if needed.
Obligatory, yes this will be on a 30 amp GFCI breaker.
Any and all feed back is appreciated!
Partlist
I'll be using craftbeerpi instead of pids. I already have the raspberry pi.
I've attached a wiring diagram and the control box part list. I'm not sure about the enclosure. Didn't know if there was a reason not to go with plastic. Also not sure how to wire an on-off-auto switch for the pump. The way I have it does not seem right. Is there any reason to avoid using an ssr for a chugger pump? I could use a regular relay if needed.
Obligatory, yes this will be on a 30 amp GFCI breaker.
Any and all feed back is appreciated!
Partlist
Last edited: