rcm_rx7
Well-Known Member
I just had some questions, and wanted to ask what other people are using for switches in their control boxes.
I like the rotary style 2 position maintained switches for my box. After reading theelectricbrewery.com I located a set of four of them on eBay for about $15 shipped. The only problem is that they are only rated for 6 amps, not even close for use with my elements (5500 watt).
It's not a complete loss as I can use at least three of them, two for pumps as one for my PID.
So where can I find a switch that can handle at least 23 amps in the same style I have pictured below? I can't find any amperage rating on eBay, and when I do they aren't near enough. My other option would be to use another relay, preferably mechanical so I don't need another heat sink. Any suggestions?
I like the rotary style 2 position maintained switches for my box. After reading theelectricbrewery.com I located a set of four of them on eBay for about $15 shipped. The only problem is that they are only rated for 6 amps, not even close for use with my elements (5500 watt).
It's not a complete loss as I can use at least three of them, two for pumps as one for my PID.
So where can I find a switch that can handle at least 23 amps in the same style I have pictured below? I can't find any amperage rating on eBay, and when I do they aren't near enough. My other option would be to use another relay, preferably mechanical so I don't need another heat sink. Any suggestions?