DrugCoder
Well-Known Member
I need to drill a port in my keggle and I don't have a step bit. Is there a favorite brand or retailer out there that you prefer? Any particular kind of step bit I need to look for to drill a hole for a 1/2" port?
I should get some thread cutting lubricant, but Pam spray has always worked...
I should get some thread cutting lubricant, but Pam spray has always worked...
I was thinking of using WD40...
Too light most likely. Better than water, but not much. You really need something a little heavier. Even light machine oil works well for drilling.
I've got some 5w30 and 10w30 motor oil...too heavy?
Nope. They would both work just fine...
Enter your email address to join: