Hey there,
Just getting back into homebrewing after probably a year or more absence. In any case I just put my first new batch into the kegerator and had to spruce it up a bit. A friend of mine was about to throw away an old solid brass perlick two faucet tower and I had him redirect it to my garage. Cleaned up nice too. So now with a two faucet setup I took the two regulator gas system i had already and i was in business....except the hole in the back of my kegerator is only big enough for one gas line, and right now i have the temp probe from my temp controller going through it.
For now I just put the tank and regs in the kegerator. There is just enough room for 2 cornies and the gas rig. After a few test beers (maybe a few too many) I started to think back on my paintball days and the macroline we would use on our paintball markers. They were 1/4" OD and handled the high pressure required for the guns (around 250psi if I recall correctly). Not incredibly flexible but they used push connectors (think like sharkbite) and there were straights, 90's and swivel fittings. Just curious if anyone on here had any experience with smaller diameter pneumatic line or something that would allow me to run two gas lines and a temp probe through a hole sized for one 5/16 gas line. The only concerns I can think of would be temperature ratings and flow rate but I suppose you shouldn't need much flow to pour a pint and as long as it can hold between 12 and 35 psi its probably good to go. Thoughts?
Just getting back into homebrewing after probably a year or more absence. In any case I just put my first new batch into the kegerator and had to spruce it up a bit. A friend of mine was about to throw away an old solid brass perlick two faucet tower and I had him redirect it to my garage. Cleaned up nice too. So now with a two faucet setup I took the two regulator gas system i had already and i was in business....except the hole in the back of my kegerator is only big enough for one gas line, and right now i have the temp probe from my temp controller going through it.
For now I just put the tank and regs in the kegerator. There is just enough room for 2 cornies and the gas rig. After a few test beers (maybe a few too many) I started to think back on my paintball days and the macroline we would use on our paintball markers. They were 1/4" OD and handled the high pressure required for the guns (around 250psi if I recall correctly). Not incredibly flexible but they used push connectors (think like sharkbite) and there were straights, 90's and swivel fittings. Just curious if anyone on here had any experience with smaller diameter pneumatic line or something that would allow me to run two gas lines and a temp probe through a hole sized for one 5/16 gas line. The only concerns I can think of would be temperature ratings and flow rate but I suppose you shouldn't need much flow to pour a pint and as long as it can hold between 12 and 35 psi its probably good to go. Thoughts?