Robizzle01
Member
I just got my 3 keg system, filled my co2 tank, hooked everything up, went to dispense my beer and ... weak stream
My dual gauge regulator shows 800psi in the tank with 10psi set on the output. I verified that the keg's IN and OUT fittings are correctly installed and have tried to dispense beer from two different kegs without much success. The beer flows very slowly out of my picnic tap.
Every time I lift the gas relief valve on either keg, I can hear and feel a gust of co2 at first, then it comes out more slowly until I leave it closed for a second. I have also put my ear against all the fittings and don't hear any leaks anywhere.
I was also a little surprised how difficult it was to install the quick disconnect (both the gas and beer out lines.) I needed to pound them on with the handle of a wrench.
Any ideas what may be going wrong? Need more information, just let me know!
My dual gauge regulator shows 800psi in the tank with 10psi set on the output. I verified that the keg's IN and OUT fittings are correctly installed and have tried to dispense beer from two different kegs without much success. The beer flows very slowly out of my picnic tap.
Every time I lift the gas relief valve on either keg, I can hear and feel a gust of co2 at first, then it comes out more slowly until I leave it closed for a second. I have also put my ear against all the fittings and don't hear any leaks anywhere.
I was also a little surprised how difficult it was to install the quick disconnect (both the gas and beer out lines.) I needed to pound them on with the handle of a wrench.
Any ideas what may be going wrong? Need more information, just let me know!