Mario-Brewing
Member
- Joined
- Feb 19, 2013
- Messages
- 6
- Reaction score
- 5
My DIY build for a routing sparge arm with no rubber gaskets. I’ve uploaded the parts list and plans, Enjoy, I will try and upload a video of it working…
The photo of the T coupler is just to show how I put it together, that was some old copper I took apart to test the idea.
The two O-Rings at the bottom are not needed I added just to stop the T coupler from sliding down when I store it upside down. The only other O-Ring I used was to hold the shaft on the wood holder it wasn’t really needed because the hole was tight enough but I added it just in case. The idea was to just put the flare at the bottom to allow it to spin and not needing the O-rings in the shaft like other builds.
The photo of the T coupler is just to show how I put it together, that was some old copper I took apart to test the idea.
The two O-Rings at the bottom are not needed I added just to stop the T coupler from sliding down when I store it upside down. The only other O-Ring I used was to hold the shaft on the wood holder it wasn’t really needed because the hole was tight enough but I added it just in case. The idea was to just put the flare at the bottom to allow it to spin and not needing the O-rings in the shaft like other builds.
Attachments
Last edited:
