ChrisVZ
Well-Known Member
I recently bought a CNC router, and decided that my first major project with it should be something for my bar. As I am a fan of the Lord of the Rings movies, I decided to make the sign from the Prancing Pony Inn.
After 6 hours of running, this is the result. It is 15”x20” and carved from a pine panel. The top right corner was lacking some detail because a bit of sagging in the center of my machine bed, but happy overall with the result.
I then gave it a light sanding to remove any large burrs or splinters, but decided to leave most of the cuts as they came off the machine to give it a somewhat hand crafted look. Then it was time to paint. This is the final result.
After 6 hours of running, this is the result. It is 15”x20” and carved from a pine panel. The top right corner was lacking some detail because a bit of sagging in the center of my machine bed, but happy overall with the result.
I then gave it a light sanding to remove any large burrs or splinters, but decided to leave most of the cuts as they came off the machine to give it a somewhat hand crafted look. Then it was time to paint. This is the final result.