BarnabyHooge
Well-Known Member
I screwed up and drilled one inch hole on a keggle for the weldless fitting instead of the 7/8. I managed to use the right one for all three of mine, but the first time I drill the hole for someone else, wrong size. Crud. I didn't even realize I had a 1" hole saw.
The set up still seems to work and I'm not getting any leaking out of the wall joint and it seem pretty solid. The only think that irks me a little is that the o-rings seem to be creeping out a lot more than mine do.
Anyway, I'd really like to plud the hole and give this guy a proper bulkhead/spout. Has anyone tried to plug one of these before? I was thinking a couple of stainless washers bolted together with some silicone material might do the trick, but I thought I'd see if anyone else had any experience.
L
The set up still seems to work and I'm not getting any leaking out of the wall joint and it seem pretty solid. The only think that irks me a little is that the o-rings seem to be creeping out a lot more than mine do.
Anyway, I'd really like to plud the hole and give this guy a proper bulkhead/spout. Has anyone tried to plug one of these before? I was thinking a couple of stainless washers bolted together with some silicone material might do the trick, but I thought I'd see if anyone else had any experience.
L