nobeerinheaven
Active Member
For Christmas, I've been fortunate to get a kegging setup. But I've had a hard time getting any beer out of the keg: I've got a pin lock setup with about 20psi to the keg and about 12' of 1/4'' ID of poly tubing. Despite that pressure, I cannot get beer out. The line barely fills when I open the tap (it does fill slightly, and very slowly, and drips out of the tap). I removed and checked the dip tube, but things seem OK.
The one thing that seems to help is if I press down on out the keg connector, the line will fill, and I can pour -- but only until that pressure is gone, and I have to do it again. Any ideas what might cause that? Bad connector?
The one thing that seems to help is if I press down on out the keg connector, the line will fill, and I can pour -- but only until that pressure is gone, and I have to do it again. Any ideas what might cause that? Bad connector?