So for give me for my ignorance, but when I tightened down my adjusting bolt I could barely turn the mill. And my 7 amp 1/2" B & D drill was not even close to doing so. I don't have any grain to mill yet but I'm pretty sure that at that setting it would be instant flour.
I placed 2 washers on each side in between the mill and the cover plate but I still don't understand what this does. Wouldn't it just make it so you have to turn the adjustment knob further and get the same result?
Going to the LHBS to grab a some grain. But from what I've read grind it until its pretty fine? No whole grains or torn husks? I've got a CPVC manifold, I've not had a stuck sparge yet so I'll cross my fingers.
Thanks for listening to me complain.
I placed 2 washers on each side in between the mill and the cover plate but I still don't understand what this does. Wouldn't it just make it so you have to turn the adjustment knob further and get the same result?
Going to the LHBS to grab a some grain. But from what I've read grind it until its pretty fine? No whole grains or torn husks? I've got a CPVC manifold, I've not had a stuck sparge yet so I'll cross my fingers.
Thanks for listening to me complain.