Gridlocked
Well-Known Member
Again, I'm keeping track of this more for my own entertainment than anything else, but feel free to hit me up with questions or tips. I like going back and seeing when I started a project so the thread posts are a great way for me to keep track of things.
The $20 Craigslist kettle.
The plan was to relieve the pressure with a 7/8" box-end wrench. The towel was to control the spray because I had no idea how much pressure was inside the keg. Turned out to be VERY little. I hooked the end of the wrench under the little tab that the tap usually slides around and pressed down. Very simple.
I pulled out the dip tube because the plan was to make a jig that fit into the hole to use as a rotation point. This was amazingly easy. Pull out a retainer clip and it slid right out. This is when I found out that five-year-old Bush Light doesn't smell the best. Don't get me wrong, it tastes better than it smells, I'm just sayin...
My jig construction failed so I took off the neck so that I could get a good line drawn around the lid I am going to use.
Rather than using the big clumsy angle grinder, I decided to use the dremmel tool and take my time. I went through three or four of the metal cutting discs that I had but I'm pretty pleased with the cut. Both my boys were sleeping so the blue sound barrier was employed to keep the noise down. Advantages of being in the industry.
The lid didn't quite fit because I wanted to cut the hole a little too small rather than a little too big. I spent a few minutes with the angle grinder and took off most of the sharpest edges and widened the hole a little bit. I still need to sand and smooth out the cut, but overall I'm pretty happy with the work.
The $20 Craigslist kettle.
The plan was to relieve the pressure with a 7/8" box-end wrench. The towel was to control the spray because I had no idea how much pressure was inside the keg. Turned out to be VERY little. I hooked the end of the wrench under the little tab that the tap usually slides around and pressed down. Very simple.
I pulled out the dip tube because the plan was to make a jig that fit into the hole to use as a rotation point. This was amazingly easy. Pull out a retainer clip and it slid right out. This is when I found out that five-year-old Bush Light doesn't smell the best. Don't get me wrong, it tastes better than it smells, I'm just sayin...
My jig construction failed so I took off the neck so that I could get a good line drawn around the lid I am going to use.
Rather than using the big clumsy angle grinder, I decided to use the dremmel tool and take my time. I went through three or four of the metal cutting discs that I had but I'm pretty pleased with the cut. Both my boys were sleeping so the blue sound barrier was employed to keep the noise down. Advantages of being in the industry.
The lid didn't quite fit because I wanted to cut the hole a little too small rather than a little too big. I spent a few minutes with the angle grinder and took off most of the sharpest edges and widened the hole a little bit. I still need to sand and smooth out the cut, but overall I'm pretty happy with the work.