CanadianNorth
Well-Known Member
Hi Folks,
I have an electric brewery setup. Recently, I upgraded to a basic RIMS setup, using coolers. My wort is transferred through Pex plumbing pipe.
The pump I used was a cheap ebay pump, and it served the purpose. Alas, recently it passed away. The excitement of brewing must have been too much for it.
I purchased the recommended March 809. However, I am wondering about the tubing size. I have heard you should have an inner diameter of 1/2" for inlet and outlet on the March. While my pex is 1/2" it is certainly not 1/2" on the I.D., and the connectors are even smaller.
Should this be a concern? ((and yes, I have a ball valve on the out connection of the pump))
Thanks!!
__________________
I have an electric brewery setup. Recently, I upgraded to a basic RIMS setup, using coolers. My wort is transferred through Pex plumbing pipe.
The pump I used was a cheap ebay pump, and it served the purpose. Alas, recently it passed away. The excitement of brewing must have been too much for it.
I purchased the recommended March 809. However, I am wondering about the tubing size. I have heard you should have an inner diameter of 1/2" for inlet and outlet on the March. While my pex is 1/2" it is certainly not 1/2" on the I.D., and the connectors are even smaller.
Should this be a concern? ((and yes, I have a ball valve on the out connection of the pump))
Thanks!!
__________________