Macro Matic secondary bracket

[Bean]

Not sure if this is the right place to post this but I'll give it a shot.

I recently picked up a set of premium secondary regs (yesterday,) which I already love but space is luxury I don't have in my keezer.. I called MM and they only have the one bracket style so I was wondering if any of you have found an aftermarket solution which will allow for the regs to mount flush on a collar and not float out or if you just fab'ed them up yourself.

any suggestions or ideas are greatly appreciated

-cheers-

 

[kh54s10]

I googled Macro Matic and can't figure out what you have. So a link to the product might help.

 

[GilaMinumBeer]

The aftermarket solution to eliminating the "stand-off" from the bracket is to remove the bracket and flatten it with a hammer.

 

[Bean]

Here is what I have
http://www.micromatic.com/premium/3-pressure-secondary-co2-regulator-premium-series-1163

and here is a link to the bracket
http://www.micromatic.com/wall-brac...nut-for-premium-series-gas-regulators-1302560

/u/GilaMinumBear, I figured that is what the solution was, or trimming the edges and rebending them lower. But since I don't have a break I figured I wouldn't be able to make two the same...