redrider736
Well-Known Member
Read as much as I could on the topic, seen what others have done. In the end I went with a Jig for a Angle Grinder. Thought this would be the best way to get a good clean uniform cut on all 3 Kegs.
Not sure what I did wrong, but the Angle Grinder (which I have owned for 8yrs but never used) burned up 3-4min into cutting my 1st Keg ??
Was I applying too much pressure/force ??
Not sure what I did wrong, but the Angle Grinder (which I have owned for 8yrs but never used) burned up 3-4min into cutting my 1st Keg ??
Was I applying too much pressure/force ??