I recently (3 weeks ago) built a dual tap tower kegerator for my husband. I got a bit lazy about building the CO2 tank shelf so we could only fit one commercial 1/6 keg to start with. That keg worked wonderfully. We tapped it and goodness flowed nicely.
I finally finished the shelf and we got a second keg. Tapped, pulled the handle, and the flow is so slow that the entire glass was just foam. I checked to make sure the valve on the regulator was turned on for this side. I tried shutting it off and pulling the release valve on the coupler to make sure CO2 was flowing through. When I turn the valve back on, I can see beer flowing through the beer line. I don't see any kinks in the beer line preventing it from flowing. We have the pressure set to 12psi.
Any tips on where to look next? We have perlick faucets on the tower. I'm really bummed the second tap isn't working.
I finally finished the shelf and we got a second keg. Tapped, pulled the handle, and the flow is so slow that the entire glass was just foam. I checked to make sure the valve on the regulator was turned on for this side. I tried shutting it off and pulling the release valve on the coupler to make sure CO2 was flowing through. When I turn the valve back on, I can see beer flowing through the beer line. I don't see any kinks in the beer line preventing it from flowing. We have the pressure set to 12psi.
Any tips on where to look next? We have perlick faucets on the tower. I'm really bummed the second tap isn't working.