Hello all,
Just finished up my Keezer and have a few questions:
1) I have the A419 programmed as follows: 44 setpoint, 6 degree differential, ASD of 10 minutes. It's programmed to SP at cutout so it runs down to 38 since that subtracts the differential. I put a cup of liquid near the top, and a cup of liquid near the bottom and let them sit there for 2.5 hours or so. Then I took them out 1-by-1 and measured the temp. Oddly - the one at the top registered 40.5 and the one at the bottom measured 41.1. I'm guessing it could either be a slight volume difference and/or the efficiency of the DC muffin fan I have inside pushing air around.
So the question is: is this normal and are the temps ok or should I make an adjustment?
2) I noticed something I don't like. I bought the faucets, line and tank as a kit. The line is Bevlex 200 5/16" ID, 9/16" OD. What I don't like is it seems the input to the manifold, and the output from the three check valves on the manifold are all 1/4" nipples. So the tube fits a bit loose. The problem is all the hoses are are already pre-connected to the ball-lock QD's so I'd rather not have to replace it all. I'm wondering if maybe they sent me the wrong manifold. Or is this common?
Thanks in advance!
Just finished up my Keezer and have a few questions:
1) I have the A419 programmed as follows: 44 setpoint, 6 degree differential, ASD of 10 minutes. It's programmed to SP at cutout so it runs down to 38 since that subtracts the differential. I put a cup of liquid near the top, and a cup of liquid near the bottom and let them sit there for 2.5 hours or so. Then I took them out 1-by-1 and measured the temp. Oddly - the one at the top registered 40.5 and the one at the bottom measured 41.1. I'm guessing it could either be a slight volume difference and/or the efficiency of the DC muffin fan I have inside pushing air around.
So the question is: is this normal and are the temps ok or should I make an adjustment?
2) I noticed something I don't like. I bought the faucets, line and tank as a kit. The line is Bevlex 200 5/16" ID, 9/16" OD. What I don't like is it seems the input to the manifold, and the output from the three check valves on the manifold are all 1/4" nipples. So the tube fits a bit loose. The problem is all the hoses are are already pre-connected to the ball-lock QD's so I'd rather not have to replace it all. I'm wondering if maybe they sent me the wrong manifold. Or is this common?
Thanks in advance!