Recently purchased the a419abg-3c electronic temp control and having issues operating. Must admit the brochure is in a different language (not really but to me). Anyone ever use and have advise on setting up and operating?
LAbrewer said:SP is the temp you want the fridge at. Dif is how much lower than sp you want the compressor to kick on. So if you want 35 degrees and the compressor to turn on at 32 then sp= 35 and dif = 3. I find that dif at 5 is good for a keezer with kegs and 2 is good for fermentation chamber.
I left that switch setup at default.
Empty fridge will have extreme differences so put a bucket of water in there or some beers.
Do you heat the fridge to 60s and 70s?
When I read the instructions it stated change for heating vs cooling. It seems to be opposite of what I want as fridge kicked on to lower
LAbrewer said:I was a little confusing in my last post. Ignore what I said. Unplug your fridge. Let the temp rise to above 70. plug it in and set the controller. The compressor will turn on at SP and off at the dif value. So on at 70 and off at 69 if sp=70 and dif=1. If it doesn't work change the switch setting.
Thanks LA- last question. My fridge has settings within - do I need to do anything special like shutoff or keep at highest?
LAbrewer said:Set the fridge to the coldest value that it has so that it will never interfere with the controller. Also make sure that the temp probe is not touching anything. drape it over a rale or something.
How do u set it to heating mode?
Enter your email address to join: