johnson a419 question

[illinoisbuck]

hey guys just bought a 419 off of a member here to start my keezer build. was wondering if i needed it to be set to cut in at setpoint or cut out at setpoint? thinking cut out at setpoint but new to this temp control game.
thanks
Buck

 

[sendkyleanemail]

I use cut in for cooling and cut out for heating.

 

[illinoisbuck]

thank you! quick response from a fellow illinoisan!

 

[day_trippr]

I would use Cooling/Cut-Out mode. In Cooling/Cutout mode the differential is above the setpoint (the target temperature). So the output relay will close when the temperature reaches the differential above the setpoint, and will open once the temperature reaches the setpoint...

Cheers!