I have a line on some 14 gauge stainless steel. Enough for a 40 gallon kettle.
We often brew for the hand full of folks that come over.
Everyone takes home a carboy.
My question is how feasable is it to get someone to weld up such a kettle?
I believe I can get it done for free but am concerned about too much of an imposition (sp?) on the poor soul that is getting "volunteered."
I am sure some grinding will be required to clean up any pits, etc.
Tig welding will be necessary.
Any insight?
A shiney new 40 gallon kettle is about $900.
tnx
r
We often brew for the hand full of folks that come over.
Everyone takes home a carboy.
My question is how feasable is it to get someone to weld up such a kettle?
I believe I can get it done for free but am concerned about too much of an imposition (sp?) on the poor soul that is getting "volunteered."
I am sure some grinding will be required to clean up any pits, etc.
Tig welding will be necessary.
Any insight?
A shiney new 40 gallon kettle is about $900.
tnx
r